Velleman DVR16H1 Guía Rápida página 5

Ocultar thumbs Ver también para DVR16H1:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

= SLOW +
P.T.Z.
Press SLOW and
Connect a USB flash drive for video backup to the left USB port (
USB port
USB mouse to the right port (
(2x)
Note: do not connect two USB flash drives or USB mice at the same time.
rear panel
LAN port
Connect the DVR to a local network by plugging a network cable into this port.
VGA
connector for video monitor*
AUDIO IN
4 audio input channels to connect four external audio sources e.g. from cameras
with audio.
AUDIO OUT
1 audio output to connect to an audio device, e.g. a speaker (mono).
VIDEO IN
16 video input channels to connect 16 external video sources e.g. cameras.
MONITOR
1 video output channel to connect the DVR to the main monitor (composite).
VGA
connect a LCD monitor to this output*
EXTERNAL I/O
use a 25 pin DSUB connector to connect external signals e.g. alarm, PTZ, ...
power switch
19V DC
Power supply input.
6. Hardware setup
Installing the Hard Disk Drive (HDD)
Refer to the illustrations on page 2 of this manual.
• Obtain a suitable HDD (not included), type SATA (Serial Advanced Technology Attachment). The
HDD must be formatted.
• Make sure to unplug the device from the mains before servicing and do not touch any electronic
circuitry to avoid electrostatic discharge.
• Unscrew the 6 screws (1 on either side and 4 on the back) that hold the cover in place.
• Lift the cover (back first).
• Screw the mounting brackets on the HDD (screws included).
Note: the PCB must be facing upwards when mounting the HDD into the DVR.
• Connect the SATA data cable and power supply to the HDD.
• Screw the HDD on the bottom of the DVR housing PCB facing upwards using the included screws.
• Close the cover (front first) and secure it with the 6 screws.
Connecting a video monitor
• Obtain a suitable monitor (not included) and connect it to the BNC or VGA video output port on the
back of the DVR.
Connecting the power supply
• Plug the DC output connector of the included power adaptor into the 19VDC power input at the
back of the DVR.
WARNING: only use the included adaptor.
• Plug the included power cable into the adaptor input connector and plug the other end into the
mains. Do not switch the DVR on yet.
Connecting a camera
• Obtain up to 16 suitable cameras (not included). Each camera needs its own power supply.
• Connect the video output of the camera to either video input at the back of the DVR. The number
next to the input connectors represents the channel number. Connector type is BNC.
Connecting audio
• The DVR supports four audio inputs. Connect the audio output of an audio source to an audio
input of the DVR. Make sure to connect the audio channel to the corresponding video channel.
Connector type is BNC.
• There is also an audio output connector. Connect an audio device e.g. a speaker to this connector
when desired. Connector type is BNC.
Connecting Local Area Network (LAN)
• Connect the DVR to a local network by plugging a network cable into the LAN port at the back of
the DVR. Connector type is 8P8C (RJ45). Setup is done through the OSD.
Connecting a USB mouse
14/04/2011
DVR16H1
simultaneous to enter or exit PTZ control mode.
).
5
); connect a
©Velleman nv
Tabla de contenido
loading

Tabla de contenido