Tabla de contenido
Idiomas disponibles
Idiomas disponibles
and other construction activities contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING:
ALWAYS use safety glasses. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if drilling operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NOSH/OSHA respiratory protection.
WARNING:
Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/
OSHA approved respiratory protection appropriate for the dust exposure. Direct
particles away from face and body.
CAUTION:
Wear appropriate hearing protection during use. Under some con-
ditions and duration of use, noise from this product may contribute to hearing loss.
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
............Read instruction manual before use
................Use proper eye protection
sfpm ........... surface feet per minute
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The table shows the correct size to use depending on
cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft.
7.6 m
15.2 m
Wire Size AWG
18
SAVE THESE INSTRUCTIONS
50 ft.
75 ft.
22.9 m
18
16
SAVE THESE INSTRUCTIONS
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
.................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
.................Use proper respiratory protection
.................Use proper hearing protection
SPM.............. Strokes per minute
100 ft.
125 ft.
30.5 m
38.1 m
16
14
4
reciprocation per minute
150 ft.
175 ft.
45.7 m
53.3 m
14
12
Tabla de contenido
