Pressure Washer Rinsing - Craftsman 580.752710 Instrucciones De Uso

Pressure Washer Rinsing
After detergent is applied, scour the surface and rinse
it clean as foJlows:
1. Apply trigger Jock to spray gun.
2. Make sure both chemical shut-off valves are in
"Off" position.
3. Remove Mack ProjectPro
TM
cleaning detergent
nozzle from nozzle extension.
4. Select and instaJJdesired ProjectPro
TM
nozzJe, as
described in "How to Use ProjectPro
TM
Nozzle
System".
5. Keep spray gun a safe distance from spray
surface.
WARNING
Keep spray nozzle between 8 to 24 inches away from
cleaning surface,
Operate this unit on a stable surface,
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location,
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
6. Apply a high pressure spray to a small area and
then check the surface for damage, if no damage,
proceed to step 7.
7. Start at top of area to be rinsed, working down
with same overJapping strokes used for cleaning.
How to Use the Hose Ree_
Your cleaning system is equipped with a hose reel
designed to store the hose when unit is not in use.
See "Prepare Unit for Storage" for long term storage of
more than 30 days.
After each use:
1. Disconnect hose from spray gun and high
pressure outlet on pump.
2. Drain water from hose.
3. SJide one end of hose into hoJe on hose reel. Turn
hose reeJ with handle to coil hose onto reel
iMPORTANT: DO NOT use your cleaning system with
the hose coiled onto the hose reel The hose reeJ is for
storage purposes only.
Automatic Coo_ Down System
(Therma_ Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circuJating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging the warm water onto
the ground.
14