Tabla de contenido
Idiomas disponibles
Idiomas disponibles
For maximum rinsing (higher pressure and
lower flow), for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red max ProjectPro
TM
nozzle.
To apply detergent, applies project specific
cleaners to help break down stubborn dirt and
grime on a variety of surfaces, select black
ProjectPro
TM
cleaning detergent nozzle.
C_eaning
and Applying
Chernicam
IMPORTANT:
Use soaps designed
specifically
for
pressure washers.
Household detergents could
damage the pump.
CAUTION
Starting
the engine
without all the hoses connected and
without the water turned ON wil!
damage
the pump.
Damage
to equipment
resulting
from failure to follow this
instruction will void
warranty.
To apply detergent follow these steps:
1.
Review ProjectPro
TM
nozzle use.
2.
Prepare chemical solution as required by
manufacturer.
3.
Pour chemical solution into chemical reservoir
labeled A or B.
NOTE: Each chemical reservoir holds two quarts.
4.
Fill other chemical reservoir with a different
prepared solution, as desired.
5.
Make sure black ProjectPro
TM
cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
6.
Make sure garden hose is connected to water inlet
and water supply is turned on. Check that high
pressure hose is connected to spray gun and
pump; start engine.
7.
Rotate chemical shut-off valve on desired
chemical reservoir to "On" position.
4.
Pull back on collar, insert selected ProjectPro
TM
nozzle and release collar. Tug on ProjectPro
TM
nozzle to make sure it is securely in place.
5.
For most effective cleaning, keep ProjectPro
TM
nozzle from 8 to 24 inches away from cleaning
surface. If you get the nozzle too close, you may
damage the cleaning surface.
6.
DO NOT get closer than 6 inches when cleaning tires.
.
g.
CAUTION
Only one
chemical solution should be used at a time to
avoid
possible
bodily
injury and/or
property
damage.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
13
Tabla de contenido
