General Frying Rules; Before First Use - Unold 58746 Instrucciones De Uso

general Frying rules

1. We recommend to use heat-resisting liquid
oil. If the oil or fat becomes brownish after
frying, it is not sufficiently heat-resisting.
Please take another oil. Never mix different
types of oil or fat since the boiling point of
different oil types is varying.
2. Do not mix used oil with fresh oil.
3. Always observe the MIN/MAX marking when
flling the recipient with oil.
4. If you use solid frying fat, set the appliance
to approx. 140 °C. Cut the fat into small
cubes of about 2 cm. Fill in a sufficient
amount of fat cubes to cover the heating
element. Switch the appliance on. As soon
as these cubes are melted add more fat
cubes until the required level between MIN
and MAX is reached. This type of fat will
become solid after cooling down.

BeFore First use

1. Take all parts such as lid, basket, handle
etc. out of the packaging. Remove all
packaging materials.
2. Clean lid, inner pan, basket, handle and
housing with warm soapy water and dry all
parts carefully.
3. Place the housing on a flat and solid dry
surface.
4. Insert the oil pan until it lies on the top edge
of the housing.
5. Insert the heating
accessories. Slide the control and heating
element firmly into the recess at the rear
element and the
5. Do not overheat the oil, as this will crust the
surface of the food and it will not be well
done inside.
6. The foodstuff must swim in the oil. Therefore
do not fry too much food in one cycle. If the
quantity is too big, the oil cools down and
the food will absorb too much oil.
7. Do not pour used oil into the sink, but
fill it into closed recipient and dispose if
according to your local regulations.
8. If you want to use the oil several times, let it
cool down and pass it through a sieve with a
filter paper inside. The oil can be stored in a
closed recipient in a cool place. Unfiltered
oil will spoil quickly.
side of the housing. The element must
engaged firmly.
6. Tilt the handle of the frying basket outwards
until it clicks into place.
7. Put the plug into a receptacle as per rating
label.
8. REMARK:
The appliance can only be switched on,
if the control element has correctly been
inserted.
19