Unpacking And Assembly - Dolmar TM-98.14 H2D Manual De Instrucciones

UNPACKING AND ASSEMBLY

3. UNPACKING AND ASSEMBLY
For storage and transport purposes, some components of the machine are not
installed in the factory and have to be assembled after unpacking. Follow the instruc-
tions below.
IMPORTANT
the engine, fill with oil and fuel following the instructions given in the engine manual.
3.1 UNPACKING
When unpacking the machine, take care to gather all individual parts and fittings, and
do not damage the cutting deck when taking the machine off the pallet.
The packaging contains:
– the machine;
– the steering wheel;
– the seat;
– the front bumper (if provided);
– the battery;
– the stone-guard components;
– an envelope containing:
– the instruction manuals and documents,
– nuts and bolts including a pin for locking the steering wheel,
– starter keys and a spare 10A fuse.
NOTE
height and take utmost care when taking the machine off the pallet.
On hydrostatic drive models: to make it easier to move or take the machine off
the pallet, put the transmission disengagement lever in position «B» (
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the protruding
shaft (2) with the spokes directed towards
the seat.
Line up the hole on the steering wheel hub
The machine is supplied without engine oil or fuel. Before starting
To prevent damage to the cutting deck, raise it to its maximum
9
EN
4.33).
1
2
3