Use; Water Disposal From The Drip Tray - CASO DESIGN HW 400 Manual De Instrucciones

3. Place vessel below the spout which can collect whole content of watertank.
4. Start the device with 0 temperature setting until ca. 300 ml water is dispensed.
5. Turn to 100°C temperature setting and let the device dispense water.
6. Process is finished once watertank is empty.
7. Device can now be equipped with waterfilter and filled with fresh water.
8. The device is ready for use.

14.2 Use

1. Fill the watertank with water,
you can remove the watertank
to do this.
2. Place a cup or similar on the
cover of drip tray. Then set the
desired temperature. Switch
the device on, the lamp lights
up in green.
3. The water is heated and flows
into the cup. Switch the device
off, when the desired amount of water is dispensed.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The ambient temperature changes everyday. This
leads to different amounts of water. It can vary up to +-
15%.
14.2.1

Water disposal from the drip tray

1. When the drip tray is full, grasp and stabilize the
device by one hand and use the other hand to lift up
the drip tray slightly to remove it.
2. Remove the cover of drip tray.
3. Empty the drip tray, replace cover of drip tray, and
insert it into the original place. Make sure it is properly inserted.
Please note
31