Installation - THERMEx MINI PERPIGNAN Instrucciones De Montaje

M 540231181226012016

INSTALLATION

The range hood is available either with an internal motor or for installation with an external motor. The range hood can either vent exhaust out into
the open air or re-circulate the air.
The hood also has a reversible exhaust outlet. If you wish to install the hood with the exhaust outlet facing towards the rear, the exhaust outlet must
be reversed before installing the hood. Follow the instructions in the section "REVERSIBLE EXHAUST OUTLET" on page 50.
Follow the instructions in this guide that match the model that you have purchased and the way in which you wish to install the exhaust outlet.
INSTALLING THE HOOD
The hood is installed on the wall using the following steps:
1
Measure out and mark the two "keyholes" on
the wall.
NOTE: For a rear-facing exhaust outlet, the
holes must be marked out in relation to the
exhaust outlet's position on the wall.
4
NOTE: The screws must not be screwed in
further than the hood can be installed.
2
x2
Drill the holes into the wall using a suitable
drill for the type of wall.
5
Hang the hood on the screws.
THERMEX MINI PERPIGNAN & MINI BORDEAUX
3
x2
Ensure that the rawlplugs and screws are
suitable for the wall material in question and
insert them into the pre-drilled holes.
6
Open the glass door and remove the filter.
47
x2
x2