Operation - Husqvarna Rider 214T Manual De Usuario

8. Put the spring eye in the holder on the tension arm
for the drive belt.
9. Remove the drive belt and put it in the belt holder.
10. Put a wooden block between the equipment frame
and the chassis. This makes sure that the cutting
deck does not spring back when removed.
WARNING: Be careful. Risk of injury if
your hand is caught between the
equipment frame and the chassis.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 9 ).
CAUTION: Incorrect type of fuel can result in
engine damage.
345 - 003 - 28.11.2017
11. Remove the 2 screws on the equipment frame.
12. Hold the front edge of the cutting deck with two
hands and pull it out.
13. Remove the wooden block.
14. Attach the cutting deck in opposite sequence.

Operation

The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
Fuel safety
11