Husqvarna Rider 214T Manual De Usuario página 19

Ocultar thumbs Ver también para Rider 214T:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
Always disconnect the charger before starting the
engine.
To do an emergency start of the engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.
To connect the jumper cables
WARNING: Risk of explosion because of
explosive gas that comes from the battery.
Do not connect the negative terminal of the
fully charged battery to or near the negative
terminal of the weak battery.
CAUTION: Do not use the battery of your
product to start other vehicles.
1. Remove the engine cover.
2. Remove the cover for the battery case.
3. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
4. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING: Do not short circuit the ends
of the red cable against the chassis.
5. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
345 - 003 - 28.11.2017
C
D
6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.
To remove the jumper cables
Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
Tire pressure
The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To put the cutting deck in servicing
position
WARNING: The drive belt tension spring can
break and cause injury. Wear protective
glasses.
To remove and attach the cutting
1. See step 1–9 in
deck on page 10 .
2. Hold the front edge of the cutting deck with two
hands and pull it out until it stops.
19
Tabla de contenido
loading

Este manual también es adecuado para:

Rider 214tcRider 216t awd

Tabla de contenido