Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
Fig. 21
6. Fit the favoured clipperhead to the blade hinge and fold it on to the
switched-on clipper by light pressure. (fig. 15, 16, 17).
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth.
The correct resharpening of blades is only to do by special machines or by
a specialist. In that case, contact your service centre.

6.2.4 Lubrication

To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (fig. 22).
CAUTION!
Unsufficient lubrication of the clipperhead causes heating and a reduced
durability of clipper and blades, as well as a reduction of the battery runtime.
Therefore:
Lubricate the blades sufficiently during the clipping (at least every
X
X
15 minutes), so that they do not drain (fig. 22).
Only use the lubricants prescribed by the manufacturer.
X
X
NOTE!
Only use our special oil or a paraffin oil meeting the ISO VG 15 specification.
The provided oil is non-toxic and produces no irritation on contact with the
skin or the mucous membranes. This paraffin oil degrades to some 20%
after 21 days (CEL-L-33-T-82).
Instruction Manual / Small animal clipper
3. Fold the clipperhead ahead
when the interlock clipperhead
is pressed.
4. Take off the clipperhead.
5. Clean the opened hinge by the
help of the provided brush.
15
Tabla de contenido
loading

Tabla de contenido