Handling And Operation; Charging Batteries - Tronic TLG 500 B1 Instrucciones De Uso

Handling and operation

Charging batteries

GB
MT
30
In this chapter you will receive important information for the handling and opera-
tion of the device.
♦ Place the device on a smooth, level and slip resistant surface.
♦ Compare the technical details with those of your power supplier. If they
match, insert the plug into a mains power socket. The LEDs
green once. The battery charger is now ready for use.
♦ Insert the batteries into the loading slots
into the loading slot
NOTICE
► 1 to 6 batteries can be individually charged:
- 4 x Type C or Type D in the loading slots
or
- 4 x Type AA or AAA in the loading slots
2 x Type 9 Volt Block batteries in the loading slots
♦ The charging process now begins. The battery charger has an LED
each compartment in the loading slot
loading slots
During the fi rst 5 seconds the battery charger carries out a capacity test:
LED Colour
Green
Green blinking
Red
Red blinking
NOTICE
► Should the LED of the loading slot
then the battery is either not properly inserted into the loading slot
it is defective.
♦ When the battery capacity has been determined, the charging process begins.
. Press the 9 V Block batteries
until they audibly engage.
show the charge status of the individual batteries.
Capacity of the
battery
> 90 %
80 - 90 %
70 - 80 %
< 70 %
blink red for more than 5 seconds,
glow red and
1 to 4
1 to 4 and additionally
5 and 6.
. The LEDs of the respective
TLG 500 B1
for
or