Assembly; Fitting The Bar And Chain - Husqvarna 440e II TrioBrake Manual De Instrucciones

Fitting the bar and chain

WARNING! Always wear gloves, when
!
working with the chain.
• Check that the chain brake is in disengaged
position by moving the front hand guard towards
the front handle. (40)
• Loosen the chain tensioner wheel and remove the
clutch cover (chain brake). Remove the transport
guard. (41)
• Fit the bar over the bar bolts. Place the bar in its
rearmost position. Place the chain over the drive
sprocket locate it in the groove on the bar. Begin on
the top edge of the bar. (42)
• Make sure that the edges of the cutting links are facing
forward on the top edge of the bar.
• Fit the clutch cover and locate the chain adjuster pin
in the hole in the bar. Check that the drive links of the
chain fit correctly over the drive sprocket and that the
chain is correctly located in the groove in the bar.
• Tension the chain by turning the wheel down (+). The
chain should be tensioned until it does not sag from
the underside of the bar. (32)
• The chain is correctly tensioned when it does not sag
from the underside of the bar, but can still be turned
easily by hand. Hold up the bar tip and tighten the bar
knob by turning the knob clockwise. (33)
• When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life. (43)
Fitting a spike bumper
To fit a spike bumper – contact your service agent. (44)
18 – English

ASSEMBLY

1155361-96 Rev.3 2017-05-03