Product Familiarisation; Unpacking Your Tool; Battery Charger Safety - Silverline 235896 Manual Del Usuario

Taladro percutor 18 v

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Additional Safety For

Battery-Operated Drills

For safety relating to protective clothing/equipment and general health

hazards relating to power tools; refer to General and Electrical Safety

sections in this manual

• Important: It is imperative to follow all national safety regulations

concerning installation, operation and maintenance

• Do not allow anyone under the age of 18 years to use this tool, and

ensure that operators are qualified and familiar with the operating and

safety instructions

• If batteries are to be charged outdoors, ensure that the power supply and

charger are protected against weather/moisture

• When using the drill, use safety equipment including safety glasses or

shield, ear defenders, and protective clothing including safety gloves.

Wear a dust mask if the drilling operation creates dust

• Use metal and voltage detectors to locate concealed electric, water or

gas lines. Avoid touching live components or conductors

• Ensure that the lighting is adequate

• Ensure that the drill bit is securely fixed in the chuck. Insecure drill bits

can be ejected from the machine causing a hazard

• Ensure that the drill bit is in contact with the workpiece prior to starting

up the tool

• Before drilling, check that there is sufficient clearance for the drill bit

under the workpiece

• Do not put pressure on the tool, to do so would shorten its service life

• Drill bits get hot during operation, allow to cool prior to handling them

• Never use your hands to remove sawdust, chips or waste close by the bit

• If you are interrupted when operating the drill, complete the process and

switch off before looking up

• Where possible, use clamps or a vice to hold your work

• Examine the chuck regularly for signs of wear or damage. Have damaged

parts repaired by a qualified service centre

• Always wait until the drill has come to a complete stop before putting

it down

• Periodically check all nuts, bolts and other fixings and tighten where

necessary

Battery Charger Safety

Use the battery charger correctly

• Refer to the section of this manual relating to use of the battery charger

before attempting to charge the battery.

• Do not attempt to use the charger with any batteries other than those

supplied. Keep your battery charger clean; foreign objects or dirt may

cause a short or block air vents. Failure to follow these instructions may

cause overheating or fire

• If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualified persons in order to avoid a hazard

WARNING: NEVER attempt to recharge non-rechargeable batteries.

Use Batteries Correctly

• Only charge batteries using the charger provided. Only use batteries

provided with this power tool, or others recommended by the supplier.

Keep batteries clean; foreign objects or dirt may cause a short. Allow

batteries to cool for 15 minutes after charging or heavy use. Failure to

follow these instructions may cause overheating or fire. When not in use

batteries should be stored at room temperature (approx. 20°C). Ensure

that batteries cannot accidentally short in storage.