Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
Installation Instructions:
1.)
Remove the rear bumper.
2.)
Remove the trim from the centre section of the rear panel and the left and right side panels
in the luggage compartment
3.)
Remove the spare wheel.
4.)
Underneath the vehicle, remove the underseal around the areas where the towbar will make
contact with the ends of the rear cross member "c".
5.)
Predrill the drilling points marked by a prick-punch to Ø 13 mm and then drill them out to Ø
18 mm.
6.)
Insert reinforcements "3" and "4" into the frame side members from within the luggage
compartment.
Note: The reinforcements are marked R and L for the right- and left-hand side.
7.)
Insert fishplates "5" at fixing points "b" and pretighten by hand with the 10.5 x 25 x 4
washers and M 10 nuts.
8.)
Align the reinforcements in such a way that the bolting points "a" align with the holes drilled
in the vehicle.
9.)
Bolt CBB basic component "1" loosely at fixing points "a" using the M 12 x 1.5 x 70 bolts.
10) Align the CBB
11.) Tighten all nuts and bolts to the specified torque:
Tightening torque for M 10 = 40 Nm
Tightening torque for M 12 = 95 Nm
12.) Refit/replace all the parts removed.
Subject to change.
10
Tabla de contenido
