Dehumidification - BALAY 3XM202H Instrucciones De Uso

Instructions for Use
when this happens. To empty the
removable tank, press the handle and
remove the tank carefully. Empty the water
down the nearest drain.
The symbol disappears from the screen
when the water tank has been emptied
and replaced on the appliance properly.
Warning!
When you turn the appliance back on
again after emptying all of the water, do
not forget to replace the removable
tank on the appliance properly. Should
you fail to do so, the symbol will not
disappear from the screen and the
appliance will not work.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before the
compressor starts up again. This period
of time is required in order to ensure
correct appliance operation.

Dehumidification

In this operation function, the appliance
reduces the humidity in the atmosphere.
The appliance purifies the air in the room
at the same time in order to create a
pleasant atmosphere.
• Plug the appliance into the mains
electricity supply.
• Fit the hot air expulsion tube outside as
indicated in "Preparing the appliance
before use".
• Lift the air director on the top of the
appliance.
There are two ways of expelling
condensed water: via the removable tank
and in continuous mode.
Dehumidification via the removable
tank:
• Check that the removable tank is fitted
onto the appliance properly and that the
plug is fitted onto the water drainage
pipe to prevent water from leaking onto
the support surface.
• The water level in the removable tank
rises. When it reaches its maximum
level, the symbol
screen. This symbol also appears when
the removable tank is not properly fitted
into its housing.
• In both events, it is necessary to extract
the tank and pour the water carefully
down the nearest drain.
Dehumidification in continuous mode:
• Place a receptacle at the end of the
water drainage pipe to collect the
condensed water or lead the pipe to the
nearest drain.
• Remove the plug from the water
drainage pipe on the back at the bottom
of the unit. When operating in this mode,
the appliance does not stop or warn that
the external receptacle is full via the
symbol .
• Select the dehumidification function
(see "Selecting the operation function").
• Select the operation speed, (see
"Selecting the speed").
Warnings
The amount of water dehumidified from
the atmosphere may reach 38 litres in
24 hours depending on atmospheric
conditions.
When the appliance is operating in the
dehumidification function, the
temperature does not appear on the
screen and cannot be selected or
modified.
Warning!
Do not forget to replace the plug onto
the water drainage pipe when you
change function, otherwise the
appliance will shed water when
operated.
Remember that ambient temperature
must be 18ºC or higher in order for the
appliance to work.
61
appears on the