Quick Installation - Tripp-Lite AG-02F0 Serie Manual Del Propietário

Quick Installation

STEP 1: Plug the UPS into
a properly grounded outlet.
After plugging the UPS into a wall outlet, press
and hold the power button until the alarm starts to
sound, then release to turn on the UPS.
Note: The UPS will not turn on automatically in the
presence of live utility power.
STEP 2: Plug your equipment
into the UPS.
There are two sets of outlets on the back of your
UPS. Outlets marked SURGE PROTECTED do not
provide battery backup power during power outages.
Connect common desktop items like printers,
scanners and other accessories not requiring
battery support to these outlets. Outlets marked
BATTERY/SURGE PROTECTED offer UPS battery
backup support during power failures. Connect your
vital computer equipment into these outlets.
Your UPS is designed to support electronic
equipment only. You will overload the UPS
if the total volt-amp (VA) ratings for all the
equipment connected to the BATTERY/SURGE
PROTECTED outlets exceed the UPS output
capacity. To find your equipment's VA ratings,
look on their nameplates. If the equipment is
listed in amps (A), multiply the number of amps
by 120 to determine VA. For example: 1A ×
120 = 120VA.
If the color LCD panel does not illuminate when the
UPS is turned ON, try the following:
1. Make sure that the UPS is plugged into a live AC
outlet.
2. Press the power button to turn on the UPS. A
beep should sound when the UPS starts.
3. If the UPS still does not start, contact Tripp Lite
Tech Support for assistance.
18-10-316-9338D9.indb 4
4
12/27/2018 1:30:21 PM