Stihl MS 201 Manual De Instrucciones página 34

English
Adjusting the Master Control lever
To adjust the Master Control lever from
run F to cold start l, press and hold
down the throttle trigger lockout and
throttle trigger simultaneously – set
master control lever.
To set the master control lever to warm
start n, first set it to cold start l, then
push the master control lever into the
warm start n position.
Switching to the warm start n position
is only possible from the cold start l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the master control lever
to jump from the warm start n position
to run F.
To switch off the engine, set the master
control lever to Stop 0.
Position cold start l
– if the engine is cold
– if the engine stalls during opening of
throttle after starting
– If the fuel tank has run empty
(engine stalled out)
Position warm start n
– If engine is warm (once the engine
has been running for approx. one
minute)
– When the engine has turned over
for the first time
– After ventilation of the combustion
chamber, if the engine was flooded
32
Version with Easy2Start
Press the fuel pump bulb several times –
even if it is still full of fuel:
– When starting for the first time
– If the fuel tank has run empty
(engine stalled out)
Holding the chain saw
There are two ways to hold the chain
saw during starting.
On the ground
Place the chain saw securely on the
N
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
With the left hand on handlebar,
N
press the chain saw firmly against
the ground – thumb wrapped
around the handlebar
Place your right foot through the
N
rear handle
MS 201, MS 201 C