Stihl MS 201 Manual De Instrucciones página 36

English
For all versions
1
Push the hand guard (1) forwards –
N
the chain is blocked
Simultaneously press the throttle
N
trigger lockout (2) and throttle
trigger (3) – set master control
lever (4)
Position cold start l
– If engine is cold (even if the engine
has stalled during opening of
throttle after starting)
Position warm start n
– If engine is warm (once the engine
has been running for approx. one
minute)
Hold and start the chain saw
N
34
When the engine has turned over for
the first time
STOP
2
Move the Master Control lever (1) to
N
4
the position warm start n
Hold and start the chain saw
N
3
Once the engine is running
Press the throttle trigger lockout and
N
blip the throttle trigger (2); the
master control lever (1) jumps to
run F and the engine begins to idle
STOP
1
STOP
1
2
Pull the hand guard toward the
N
handlebar
The chain brake is released – the chain
saw is ready for use.
Open the throttle only when the
chain brake is off. Increased
engine speeds with the chain
brake on (saw chain is stationary)
will quickly damage the clutch and
chain brake.
At very low temperatures
Let the engine warm up briefly with
N
the throttle slightly open
If necessary, configure for winter
N
operation – see "Winter Operation"
Switching off the engine
Move the master control lever to the
N
stop position 0
If the Master Control lever was moved
from the position warm start n to stop 0
– afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
MS 201, MS 201 C