Safety Instructions - Urrea 2469 Manual De Usuario Y Garantía

SAFETY INSTRUCTIONS

• This press has been designed for general
bending, toughening, axis and bearing
extraction work etc. Never use it for
applications that should not be performed
by a press.
• Always use the appropriate tool for each
specific task.
• Handle the press correctly and ensure that all
parts and components are in good condition
and that no parts are missing prior to its use.
• The press should only be used by authorized
persons, having
understood the contents of this manual and
the assembly instructions.
• Do not modify the press in any way.
• Non-compliance with these instructions may
result in injury or damage to the user, the
press or the piece being manipulated.
• The manufacturer accepts no responsibility
for the improper use of the press or the
component handled.
• Noise level less than 70 dB for pneumatic
presses.
• Never exceed the rated capacity of the press.
• Always position the press against a wall. If
the press is situated in the open workshop,
it is essential that a guard be placed at the
rear of the unit. This will prevent injury to
bystanders in the event of the work piece
ejecting suddenly.
• The work tables, and presses in general,
are heavy elements which must be handled
with care. In presses which are not equipped
with a winch, the user must request the
help of other people to position the table
in its work position and / or whenever the
working height needs to be altered.
• Do not introduce hands or any other part of
the body in the work area.
• Exposed personnel in the work zone are
obligated to protect their feet, face and
hands. Steel or other materials may splinter
or fall due to the strong pressure put on
them by the press.
• Never wear baggy clothes, ties, watches,
rings, chains, etc. when using the press. Long
hair should be tied up.
• As a safety measure, the models equipped
with an independent pump and cylinder
have an overload valve, set at its maximum
read carefully and
working pressure at the factory. This valve
should not be tampered with under any
circumstances.
ASSEMBLY
Number Description
1 Tank
2 Cylinder
3 V Block
4 Axle
5 Manometer
6 Cover
7 Pump
8 Table
9 Frame
10 Leg
E N G L I S H
7