Maruyama BT230L Manual Del Propietario U Operador página 16

Cold Starting Procedure
This Trimmer is equipped with a fuel primer and a
choke system. To start a "cold" engine properly,
perform the following procedure:
1. Pump the primer bulb at the bottom of the carburetor
until fuel can be seen flowing through the fuel
return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy
or full of bubbles.)
Choke Lever
Close
Primer Bulb
2. Move the choke lever to the closed (
And move the control lever to the high speed side
approximately half in. from the low speed side.
L:
Low speed
H:
High speed
Open
Choke Lever
Starter Grip
Fuel
Return
Line
) position.
Throttle Trigger
Control Lever
Throttle Lever
Fast-idle lock button
3. Grasp the throttle lever then push the fast-idle
lock button. Release your hand with holding the
fast-idle lock button to lock the fast-idle.
4. Pull the starter grip.
5. After the engine starts, squeeze and release the
throttle lever to return it to the idle position. Then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
Go ahead and open the choke, pull the starter grip
with the throttle trigger positioned at Fast-idle
position.
POTENTIAL HAZARD
• The components of your recoilstarter
assembly are under high spring tension.
If improperly disassembled these parts
maystrike you with considerable force,
possibly causing personal injury.
WHAT CAN HAPPEN
• Contact with the parts can cause severe
personal injury.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your
recoil starter assembly yourself.
A lways consult your authorized
M ARU YAM A dealer for repair by
qualified service technicians.
• Do not pull the Starter rope all the way
out.
— US-15 —
) position.
) position:
WARNING
CAUTION