Testing Your Fan - Craftmade Ellington DCF52BNK5 Guia De Instalacion

10. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF position
(no blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull will
set the fan to LOW. Fourth pull will again set the fan
to the OFF setting. If fan does not function, please
refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (diagram 1)
- UP position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 3), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to end of the pull
chain.
reverse
switch
diagram 1
page 8
motor housing
diagram 2 diagram 3