Fan Assembly. Pgs - Craftmade Ellington DCF52BNK5 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. Fan Assembly (with downrod). (cont. )
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you once
you are set on the ladder.
Continue to "Wiring" section on page 6 for wiring diagram.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to reveal
6 holes. Notice that 3 of these holes are larger.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph. If
there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Thread wiring through canopy. Place canopy
over yoke, aligning larger holes in canopy
with the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 lock
washers that had been removed (if there were
only 3 screws located in top of motor housing,
these screws/lock washers will be located in
one of the hardware packs) into the
remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over
the hanging bracket tab. (Use one of the
non-slotted holes on the rim of the canopy to
do so.)
page 5
hanging bracket tab
hanging ball slot
canopy
canopy cover
canopy
yoke
motor housing
canopy
hanging bracket tab
motor housing

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ellington dcf52fbz5Ellington dcf52mww5

Tabla de contenido