Skil 2888 Instrucciones De Funcionamiento Y Seguridad página 16

SM 1619X04215 05-09:SM 1619X04215 05-09 5/21/09 3:09 PM Page 16
RUNNING NUTS AND BOLTS
Variable speed control must be used with
caution for driving nuts and bolts with socket
set attachments. The technique is to start
slowly, increasing speed as the nut or bolt runs
down. Set the nut or bolt snugly by slowing the
drill to a stop. If this procedure is not followed,
the tool will have a tendency to torque or twist in your hands when the nut or bolt seats.
HOLE SAWS
Keep hands away from
W RNING
cutting area and hole saw.
Service
NO USER SERVICEABLE
W RNING
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard. We recom-
mend that all tool service be performed by a
Skil Factory Service Center or Authorized Skil
Service Station. SERVICEMEN: Disconnect
tool and/or charger from power source before
servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
can cause the tool to operate improperly or
damage the charger.
(NICKEL-CADMIUM BATTERIES ONLY)
Long term battery storage should be in
the discharged state. Battery packs last
longer and re-charge better when they are
stored discharged. Remember to fully re-
charge battery packs before using after
prolonged storage.
TOOL LUBRICATION
Your Skil tool has been properly lubricated
and is ready for use.
Keep your second hand on the side
handle or motor housing. If both hands are
holding the drill, they cannot be cut by the
hole saw. Hold the drill firmly to prevent loss
of control. Unplug drill when removing core.
Hole saws are ideal for use with lock
installation kits for 2-1/8" deadbolts or
locksets with 15/16" or 1" latch hole in
wooden and composition doors.
Maintenance
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Skil replacement motor
specially designed for your tool should be
used.
W RNING
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with compressed dry air. Always
wear safety goggles when cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
C UTION
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
-16-
D.C. MOTORS
Cleaning
To avoid accidents, always
disconnect the tool and/or
Certain cleaning agents
and solvents damage