Craftsman 247.883961 Manual Del Operador página 10

7. Push the chute control rod toward the control panel until the hole in the rod
lines up with the middle hole in the chute control input and insert the cotter
pin. See Figure 8.
NOTE: There is a reference hole provided at rear end of control rod to help
know when holes are vertical.
NOTE: The hole furthest from the chute control head is used to achieve
further engagement of the chute control rod into the input shaft if required.
Refer to the Maintenance & Adjustments section for Chute Control Rod
adjustment.
The hole closest to the chute control head is used for manual movement of
the chute assembly if required. Refer to the Controls & Features section.
8. Check that the cables are properly routed through the cable guide on top of
the engine. See Figure 9.
NOTE: For smoothest operation, the cables should all be to the left of the
chute control rod.
Set-Up
Shear Pins
Holes are located in the plastic dash panel for convenient shear pin storage. See
Figure 10. Refer to the Operation section for more information regarding shear pin
replacement.
Figure 8
ASSEMBLY
10
Figure 9
Figure 10