NAMCO MAZAN Manual Del Operador página 5

NOTES ON INSTALLATION
NEVER turn the power to the machine ON until installation has
l
been completed.
In order to prevent possible electric shocks, be sure that the
l
equipment is connected to the mains with a securely
connected earthed plug.
So that customers are not injured by the movement of the
l
equipment, ensure that there is at least 500mm seperation
between other equipment or walls.
In order to avoid damage to the equipment due to mis-operation,
l
ensure that the voltage of the mains supply is 230volts AC.
Note: If the location of this equipment has a polished floor, it is
recommended that rubber pads are fitted under the level adjusters
to prevent the equipment sliding on the floor when in use.
Note: In order to gain access to the Power Supply and CPU assemblies,
ensure that the rear of the equipment is seperated from a wall or
other equipment by at least 500mm
This equipment is fitted with castors to make it easier to move. Take care when moving the
l
equipment on an inclined surface.
The fitting position of the Header Assembly is high, and it is important that a means of reaching the
l
height safely, without stretching, is available. (e.g. Steps, Step Stool etc.)
The overall height of the equipment , with the Header Assembly fitted, is 2220mm. Take care of any
l
overhead obstructions. (e.g. Light Fittings, Electric Cables etc.
Adjustments or maintenance on this equipment should be carried out by suitably qualified
l
personnel only.
Do not make any alteration to this equipment without prior approval. Doing so could cause
l
unforeseeable danger.
Only parts specified by Namco Europe Ltd. should be used when replacing parts. (Including
l
screws)
Ensure that the power to the equipment is turned OFF before commencing any maintenance work.
l
(Trouble shooting, repairs etc.)
If performing work not described in this manual, contact your distributor for instructions, as no
l
responsibility will be accepted for damage or injury.
Parts of the Power Supply and Monitor remain hot and carry high voltage even after switching OFF
l
and could cause burns or electric shock. Take care not to touch these parts accidentally.
Make sure that the equipment is switched OFF before connecting or disconnecting any plugs or
l
connectors.
l When moving the mains connector from the equipment, or the mains plug from the wall outlet,
l
always grasp the plug and not the cable.
MOVING THE EQUIPMENT
REMOVING AND REPLACING PARTS
Page 5
3m10cm min.
50cm min. 50cm min.
Play Area
Pathway