Tabla de contenido
Idiomas disponibles
Idiomas disponibles
There are two adjustment screws in the Sensor Assy and these make adjustments to a
pair of sensors together.
HORIZONTAL
ADJUSTMENT SCREW
2 , 1º
2 , 1º
2 , 2º
2 , 2º
VERTICAL
ADJUSTMENT SCRE
The angle of the sensor can be changed by approx. ±2º by turning each adjustment
screw (approx ±5.7mm).
Adjustment
Slacken slightly 2off cap screws under the sensor bracket, so that the sensor
assembly can move by turning the adjustment screws.
Note: If the screws are slackened too much, there will be too much movement of the
sensor bracket, and adjustment cannot be made correctly.
After adjustment is completed re-tighten the 2off cap screws and check that the sensor
levels are still correct.
Page 42
Tabla de contenido
