Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. 1
A. Exhaust deflector
B.
Trigger
C.
Air Inlet with quick connect coupler
D. Canister
E.
Door latch
F .
Safety contact tip
G. Depth adjustment wheel
H. Door
I.
Tool-Free Shingle Guide
Disconnect air line from tool and remove fasteners from
magazine before making adjustments or personal injury may result.
TRIGGER
Keep fingers AWAY from the trigger when not driving fasteners to
avoid accidental actuation. Never carry a tool with your finger on the trigger. In
bump action mode (contact actuation mode), the tool will drive a fastener if the
contact trip is bumped while the trigger is depressed.
AIR FITTING
A 3/8" (9.5 mm) male quick connector coupling may be used when a 1/4" (6.4 mm)
supply line is not available.
Always use couplings that relieve all pressure from the tool when it
is disconnected from the power supply. Always use hose connectors that shut off
air supply from compressor when the tool is disconnected.
To install an air fitting
1.
Wrap the male end of the fitting with thread seal tape prior to assembly to
eliminate air leaks.
2.
To install a 1/4" (6.4 mm) fitting: screw it directly into the air inlet and tighten
firmly. NOTE: If an adapter is in the air inlet, remove it prior to inserting the
fitting.
3.
To install a 3/8" (9.5 mm) fitting: screw the fitting into the 3/8" (9.5 mm) adapter
and then into the air inlet of the tool and tighten firmly.
TOOL PARTS
G
ASSEMBLY
7 - ENG
A
B
E
H
F
C
D
I
Tabla de contenido
