Safety Instructions; Loading The Tool - Stanley Bostitch SB-156SXHD Manual De Instrucciones

SAFETY INSTRUCTIONS

IMPORTANT READ CAREFULLY: It is important that all operators read and understand all sections of
this Tool Technical Data manual and the separate Safety and Operating Instruction Manual which come
with this tool. Failure to do so could result in you or others in the working area to be seriously injured.
WARNING! Eye protection in accordance with 89/686/EEC, and with equal or greater grade than defined in
EN166 should be used. However all aspects of operators work, environment and other type/s of machinery
being used, should also be considered when selecting any personal protection equipment. Note: Non-side
shielded spectacles and face shields alone do not provide adequate protection.
WARNING! To prevent accidental injuries:
•
Never place a hand or any other part of the body in fastener discharge area of tool.
•
Never point tool at yourself or anyone whether it contains fasteners or not.
•
Never engage in horseplay.
•
Never pull the trigger unless the nose is directed towards the work.
•
Always handle the tool with care.
•
Do not pull the trigger or depress the trip mechanism whilst loading the tool.
•
To prevent accidental actuation and possible injury, always disconnect air supply.
1. Before making adjustments. 2. When servicing the tool. 3. When clearing a jam. 4. When tool is not in use.
5. When moving to a different work area, as accidental actuation may occur, possibly causing injury.
•
Read the additional Safety & Operating instructions booklet before using tool.
•
Do not use oxygen and combustible gases as an energy source for pneumatically operated tools.
•
The operation of this tool can cause sparks and act as a source of ignition for flammable fuels and gases.

LOADING THE TOOL

1. Depress magazine release button and pull back magazine. (Fig. 1)
2. With magazine fully open, insert fasteners. Points must be against bottom of magazine. (Fig. 2)
3. Push magazine forward. Continue pushing until latch is engaged. (Fig. 3)
Note: Use only fasteners recommended by Stanley for use in Stanley Tools or which meet Stanley
specifications.
Important Note: Steel fasteners are made from galvanized steel wire and are not treated after they are
manufactured. As such, we do not guarantee or warranty product against corrosion for any specified time.
"DIAL-A-DEPTH™" FASTENER CONTROL ADJUSTMENT (Fig. 4)
The DIAL-A-DEPTH™ Fastener Control adjustment feature provides close control of the fastener drive depth;
from flush with the work surface to shallow or deep countersink. First, set the air pressure for consistent drive in
the specific work, then use the DIAL-A-DEPTH™ Fastener Control adjustment to give the desired depth of drive.
ADJUSTING THE MULTI-DIRECTIONAL EXHAUST
To adjust the multi-directional exhaust, simply rotate the exhaust deflector in a desired position as illustrated:
arrows. (Fig. 5)
All manuals and user guides at all-guides.com
GB