Getting Started; Set-Up Mode - AEMC Instruments CA7026 Manual De Instrucciones

4..3

Getting Started

The instrument is switched on and off using the green power button
found on the lower right side of the front panel. When the unit is first switched
on it will display the opening screen giving the software version, the currently
selected Vp (Velocity of Propagation), cable impedance and battery status
indicator.
4..4

Set-up Mode

Hold down the
up mode.
• Vp can be set in the range 1% to 99% (see § 4.8)
• Z, the cable impedance, can be set to 50, 75 or 100Ω
• Measurement units can be set to Feet or Meters
• The display contrast can adjusted
Press the
TEST /
Press the and buttons to change the setting of the line selected.
Press the
TDR /
When the Fault Mapper Pro
current set-up parameters.
This feature is useful in the situation where the operator is per-
forming many tests on the same type of cable.
Fault Mapper Pro
AEMC Instruments
Fault Mapper Pro V1.0
Vp=70% Z=100Ω
button, then press the
TDR /
> Vp=72%
Z=100Ω
Feet
Contrast
button to move the line selector (>) down the screen.
button again to save changes and exit set-up mode.
® Model CA7026
TEST /
is turned off, it will remember the
®
button to enter set-
,