11
USB INTERFACE
USB interface to update the device firmware. In the Service menu, set USB Update to ON. Download, when available, the current
firmware from the product page at www.cameolight.com, unzip it, and copy the files to a folder without any special characters on a USB
stick. Disconnect the moving head from the power and all input connections (DMX / Ethernet), connect the USB stick via the USB port, and
then reconnect the moving head to the power. The USB stick will be automatically detected and shown on the display. Now navigate to the
corresponding folder on the USB stick and confirm this via "ON". The update process will begin. Do not remove the USB stick or disconnect
the moving head from the power during the update process.
The battery-powered display can be activated even if the device is not connected to the power. To do so, press and hold MODE for a period
of 12 seconds. You can now view device information and change and save system settings, even if the device is not connected to the
power. The external control of the spotlight will not activate in this case. This means that the display will show that there is no control signal
present, even if there is one present for the device.
12
OPERATION
NOTE
As soon as the spotlight is connected correctly to the power, "Software Update Please
Wait..." and the Cameo logo with information on the device model will display while the
device starts up and the motor resets. The spotlight is ready after this process, and the
operating mode that was selected will activate.
The spotlight can be operated using the touch-sensitive control fields next to the display,
or the pressure-sensitive display (can be used with gloves) itself can be used to access
all menu options and intuitively modify settings as desired. Information on which control
element on the display and which control field next to the display have the same functionality
can be found in the adjacent table.
The following describes how to operate the device using the control fields next to the display.
12
PAN LOCK
Mechanical locking mechanism to prevent the head from turning in a horizontal
direction during transport. Disconnect the device from the mains power, bring
the head parallel to the base (4 possible positions) and press the locking lever
in the direction of the pan rotation axis. Unlatch the mechanism before starting
up the device.
13
TILT LOCK
13
Mechanical locking mechanism to prevent the head from turning in a vertical
direction during transport (7 positions). Disconnect the device from the mains
power and push the locking lever in the direction of the tilt rotation axis while
moving the head of the device on vertical level until one of the 7 locking
positions is found and the locking lever engages. Unlatch the mechanism before
starting up the device.
Control field
7