Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating Instructions
During break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During operation
After a long period of full-throttle
operation, allow engine to run for a while
at idle speed so that the heat in the
engine can be dissipated by flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After finishing work
Wait for engine to cool down. Drain the
fuel tank. Store the machine in a dry
place. Check tightness of nuts and
screws (not adjusting screws) at regular
intervals and retighten as necessary.
TS 510, TS 760
Cleaning the air filter
2
3
1
Soiled air filters will reduce the engine
performance, increase fuel consumption
and make it more difficult to start the
machine.
If the engine performance declines
tangibly:
:
Set the choke lever (1) to the
"cold start" position l.
:
Unscrew the locking nut (2) on the
filter cover.
:
Remove the filter cover (3).
:
Clean the area around the filter and
the inside of the filter cover to
remove all coarse dirt.
English / USA
4
5
:
Grasp the prefilter (4) by the tabs
(arrows) and pull it off the main filter.
Wet prefilters must be dried before
being knocked or blown clean.
A new prefilter must be fitted if the dirt
cannot be removed in this way.
Use two prefilters alternately.
:
Check the main filter (5).
It must be removed and replaced if
soiled or damaged.
The auxiliary filter must always also
be replaced together with the main
filter.
27
Capítulos
Tabla de contenido
