Replacing The Starter Rope And Rewind Spring - Stihl MS 271 Manual De Instrucciones

Ocultar thumbs Ver también para MS 271:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Too much oil in fuel mix.
Dirty air filter.
Unfavorable running conditions,
e.g. operating at part load.
Warning!
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press spark plug boot (1)
snugly onto spark plug terminal (2) of
the proper size. (Note: If terminal has
detachable SAE adapter nut, it must be
attached.) A loose connection between
spark plug boot and ignition wire con-
nector in the boot may create arcing that
could ignite combustible fumes and
cause a fire.
MS 271, MS 291, MS 291 C
Installing the spark plug
1
N
Insert the spark plug through the
grommet and screw it in by hand.
N
Tighten down the spark plug, fit the
boot and press it down firmly.
N
Install the shroud – see "Shroud".
2
Replacing the Starter Rope
and Rewind Spring
Remove the fan housing
N
Remove the shroud – see "Shroud"
1
1
N
Remove screws (1)
N
Push hand guard upward
N
Pull the bottom of the fan housing
away from the crankcase and
remove downwards
Remove the rope rotor
For standard versions
2
1
N
Carefully press the spring clip (1) off
of the axle with a screwdriver or
suitable pliers
N
Carefully remove the rope rotor with
washer (2) and pawl (3)
English
1
1
3
43

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ms 291

Tabla de contenido