Connecting To A Computer - Sony VPL-VW12HT Manual De Instrucciones

Left side
CONTROL S IN
PLUG IN POWER S VIDEO
TRIGGER
REMOTE
RS-232C
(FOR SERVICE USE)
to RGB/
component/
progressive
component
output
15k RGB/Component equipment
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
• To connect a 15k RGB/component/progressive
component equipment, select the COMPUTER/
COMPONENT/DTV YP
INPUT-A or INPUT-B in the SET SETTING menu
according to the input signal.
For details on setting, see page 30 (GB).
• You can connect a high definition equipment. The
connection method is the same as above.
VIDEO IN
VIDEO
INPUT A
G/Y B/C /P R/C P SYNC/HD VD
B B R/ R
INPUT B
G/Y B/C /P R/C P SYNC/HD VD
B B R/ R
Pin cable
(not supplied)
or
Active speakers
P /DTV GBR in the
B R

Connecting to a Computer

This section describes how to connect the projector to
a computer.
(For further information about an example of connection,
see the next page.)
Select the "COMPUTER" in the INPUT-A or
INPUT-B of the SET SETTING menu.
Notes
• The projector accepts VGA, SVGA, XGA, and
SXGA signals. However, we recommend that you
set the output mode of your computer to XGA mode
for the external monitor.
• If you set your computer, such as a notebook type, to
output the signal to both your computer's display
and an external monitor, the picture of the external
monitor may not appear properly. Set your computer
to output the signal to only the external monitor.
For details, refer to the operating instructions supplied
with your computer.
• Connect all the connecting cables to the INPUT A
connector when you input a signal from the INPUT
A connector.
Connect all the connecting cables to the INPUT B
connector when you input a signal from the INPUT
B connector as well.
Connecting the Projector
17
(GB)