Signature Hardware VELA Manual De Instrucciones página 24

V E L A & V E L A P L U S
SMART TOILET
INODORO INTELIGENTE
WC INTELLIGENT
SKU: 473602, 473603
REMOTE INSTALLATION
1. Drill two 6mm (1/4 inch) diameter holes on the wall (about 1-3/4" deep).
2 Knock the anchors into the hole with a hammer.
3. Secure the holder with anchors.
4. Use the screws to secure the holder to the wall.
5. Remove the battery cover from the backside of the remote to install batteries.
6. Once �nished, remote is ready to be placed in its holder.
Detailed steps in the diagram below:
*Please use proper mounting tools for special wall surfaces (such as wood, HDF, etc)
*The remote control holder should be installed away from the bidet's spray trajectory
*The remote control holder should be installed within reach when seated on unit
*Make sure there is nothing to block the transmission between the toilet and its remote.
STEPS
> 1-3/4"
"
1 / 4
Remove the
decoration strip/
Anchor
remote control stand
Replace
Screws decoration strip
24
Complete
Remote control
1.855.715.1800