Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Device elements (fig. I)
Overview
1 Detachable tank
2 Discharge control wheel
3 Product control wheel
4 Control lever
5 Safety hood
6 Protective guard
7 ¼" compressed air supply
8 Protective guard mounting fastening ring
9 Handle
10 Hanging hook
11 8 bar safety valve
WB Optional valve for (water-based) guns
Intended use
The device is intended for use in spraying bitumen,
rubber, plastic, synthetic resin and wax-based liquid
underseal/stone chip protection and hollow space
sealing products from special containers. The device
is intended for use with genuine Würth system acces-
sories. Any other use is considered improper.
The user is liable for any damage in the
event of improper use.
Technical data (fig. VI)
Item
Air consumption
Working pressure
Max. pressure:
Recommended max.
hose length
Min. inside diameter
of the hose
Air connection
Nozzle diameter
Net weight
Tank content
A pressure reducer with a filter [16], a pressure
meter [15] and a shut-off valve [17] for shutting off
14
0891 110 500
Approx.
200 - 300 l/min
4/6 bar
8 bar
10 m
6 mm
Air quick release
coupling
Ø1.2 mm
1935 g
1 l
the air supply are required in the compressed air
system.
Noise and Vibration Information
The equivalent continuous sound pressure level,
calculated on the A scale, is measured at a horizon-
tal distance of 50 cm. For bituminous products, this
level is <80 dB(A).
Operation (fig. III, IV, V)
Attention!
Dirty pipes could damage the device.
¾ Never tip the device through more than 45°.
¾ Do not close the device during use.
¾ After use, hand the device by the hanging
eye [7].
Connect the nailer to the compressed air supply.
■
Observe the technical data.
WARNING!
Danger due to pressure release
 The detachable tank [1] is under
pressure.
¾ Before the detachable tank [1] is
unscrewed, the safety valve [3]
must be turned clockwise to
release the contained pressure.
Unscrew the detachable tank in an anticlockwise
■
direction (fig. 1/III).
Assembly
Unscrew the protective guard in an anticlockwise
■
direction and remove from the protective guard
mounting.
Select a suitable probe for the work to be
■
performed and attach on the protective guard
mounting.
Screw the probe in the clockwise direction
■
(fig. 2/IV and 3/IV).
Product supply
Disconnect or interrupt the air supply and pull on
■
the ring of the safety valve [11], to let air out of
the tank [1].
Tabla de contenido
