Pushing And Pulling The Machine - IPC CT80 Manual De Instrucciones

► Open the hook (fig. 27, ref. 1).
► Push the two blade pressing devices (fig. 27, ref. 2) outwards, then remove them.
► Remove the blade.
► Reuse the same blade by reversing the edge in contact with the floor until all four edges
are worn out, or replace with a new blade, fitting it onto the screws on the body of the
squeegee.
► Reposition the two blade pressing devices by centering the wider part of the slots on the
squeegee body fastening pins, then push the blade pressing devices inwards.
► Close the hook again.
► Replace the squeegee on its support, following the instructions described previously.
27

Pushing and pulling the machine:

When the electric drive cannot be used, the machine can be easily pushed or pulled by turning the
lever (fig. 28) clockwise, so as to release the electric brake. After moving the machine, set the lever
back to the original position.
If the lever is in the position where the electric brake is disengaged (lever turned clockwise),
Never start the machine with the electric brake disabled.
! WARNING!
the machine's brake will be disabled.
28
1
GB 34