Working
►
Sit correctly in the seat.
►
Turn the main switch to position "1".
►
Select the direction of travel with the direction selector.
►
Select the AUTO or ECO program.
►
Press the accelerator pedal to move off and start work.
Some useful tips to get the most from your scrubber drier
In the event of particularly stubborn dirt on the floor, washing and drying can be performed in two
separate operations.
Prewashing with brushes or pads:
►
Turn the main switch to position "1".
►
Select the AUTO or ECO program.
►
Press the suction motor button to stop suction.
►
Press the accelerator pedal to move off and start work.
►
If necessary, adjust the flow of detergent delivered to the brush, using the water/detergent
button; the outlet flow must be metered in relation to the required travel speed; the slower
the machine travels, the less detergent must be delivered.
►
Persist when washing particularly dirty points to give the detergent time to perform its
chemical action detaching and suspending the dirt and the brushes time to exert an effec-
tive mechanical action.
Drying:
►
Lower the squeegee and with the suction motor on, pass over the same area washed pre-
viously. The result is equivalent to in-depth washing and subsequent ordinary maintenance
will take less time.
Emptying the collection tank:
If the tank is full, the display shows the corresponding alarm, see
seconds, the suction motor shuts down, then stop the machine and empty the tank following the
instructions shown below:
►
Switch off all the machine's functions.
►
Take the machine to the disposal area.
►
Unhook the hose from the clip.
►
Empty the tank using the hose (fig. 13, ref. 1), at the end rinse the tank with clean water.
13
1
1
GB
"Display
alarms"; after a few
24