Makita 440 Manual De Instrucciones página 21

6
.... CLEANING THE DRUM (container) (fi g. "D9")
- Check the amount of debris vacuumed particularly if used for voluminous mate-
rials.
- We recommend emptying the drum when it is half full.
- After using the appliance as a wet vacuum, empty the drum and dry it and the at-
tachments to prevent caking
7
.... REPLACING THE POWER CORD
- Contact an authorised Makita service centre if the power cord has been damaged,
since special tools are needed to replace it.
======================================================================
EFFECTS
---------------------------------------
• The appliance won't start.
======================
• Dust is coming out of the
exhaust grating.
======================
• Reduced effi ciency
(suction).
======================
• The rpm rate of the motor
is noticeably higher.
======================
• The appliance will not
start in the "power tool"
mode.
======================
PROBLEMS?
CAUSES
-----------------------------------------
• No power.
• Defective power cord, switch
or motor.
=========================
• Clogged or worn fi lter
system.
=========================
• Drum is overfull.
• Clogged or worn fi lter
system.
• Clogged tube or
attachments.
=========================
• Drum is overfull.
• Clogged or worn fi lter
system.
• Clogged tube or
attachments.
=========================
• Defective circuit board.
=========================
- 21 -
SOLUTIONS
-----------------------------------------
• Check that the power
supply is on.
• Contact your
technical service centre.
=========================
• Replace or clean fi lter
systems (paragraph "B"
page 18-19).
=========================
• Empty drum.
• Clean or replace fi lters.
• Check the hose or
attachments.
=========================
• Check the drum.
• Clean or replace fi lters.
• Check the hose or
attachments.
=========================
• Contact your
technical service centre.
=========================
EN