Schüco 1600 Pro Manual Del Usuario página 32

5.3 Programming the battery voltages and
absorption time
The voltage levels (low voltage, fl oat charge, end
of charge and equalization) and the duration of the
absorption charge can be changed.
The display of these voltages and the times in the
program mode are in accordance with the diagram
shown below:
The programming is done in accordance with the
following steps:
- Push and hold down, the Push Button
(Program) and the Push Button
status) for minimum 2 seconds simultaneously.
- With the Push Button
the battery level and the absorption time to be
changed.
These four red LED show the function set:
- Equalization LED
- Absorption (End of charge) LED
- Float charge LED
Table of voltage and timing threshold
LED Low voltage
LED
24.0
23.6
23.2
22.8
22.4
The heavy printed values show the standard settings.
34
(Change
(select) select with of
Float Charge
LED
27.4
27.2
27.0
26.8
26.6
231 575
- Absorptions Time LED
- Low voltage LED
- With the Push Button
the desired parameter (voltage or the time)
to modify (LED
Button (Change status) to set the desired
value accord-ing to the table ‎ 6 .3.1.
- If desired, repeat the operation with any other
parameter (voltage or time) to be changed.
- If during seconds no buttons are pressed,
the selected values are automatically stored and
the Inverter 1600 Pro switches back in to the
normal operating status.
The voltage levels and times changed
through programming are only fi rst active
with the next charge cycle!
Caution!
A wrong setting of battery voltage can
drastically reduce the battery lifetime.
Please contact your battery supplier to
choose the right setting.
Absorption Equalization
LED LED
32.4 32.4
31.2 31.8
30.0 31.6
28.8 30.6
28.4 30.0
/ / /
(Change status) set
, , , , ). Push
Absorption
Time
4 h
3 h
2 h
1 h
0 - 1 min
02.2008