Schüco 1600 Pro Manual Del Usuario página 27

Light Emitting Diodes (LED)
LED Marking
AC IN
Charger
Program*
Contact active*
Contact manual*
Transfer*
AC OUT
Inverter*
Over Temp.*
Overload*
Batt. Low/High
Off
Gasung*
Charge condition of
... Battery*
Current
Monitor*
* only on the Remote Control Pro
02.2008
LED lit
AC In Voltage at the AC IN
input is within the accepted
range (voltage and frequency)
Battery Charger is working
Program
Contact active
Contact manual
Transfer system is active.
In-put AC voltage is directly
connected to AC OUT output
Voltage is present at the AC
OUT output
Inverter is working
For the time being the Inverter
1600 Pro is out of service be-
cause of overheating.
The Inverter 1600 Pro is out of
service because of overload or
short-circuit
Battery voltage is too low
Inverter 1600 Pro is turned off.
Turning it back on is only possi-
ble manually.
Battery Charger is doing an
equalization cycle
Charge condition of Battery
25% / 50% / 75% / 100%
Display the value of the output power in % of Pnom (in Inverter Mode) and the
charge current in Amps. (in Charger Mode)
231 575
LED blinks
Voltage, outside of the self-adjusted values is
at the AC IN input.
The input voltage is out value (volt-age or
frequency) or the charger is disabled by lock
mode
Program mode for Aux. Contact
Auxiliary Contact is activated
Aux. Cont. manually activated
Transfer system (by-pass) is disabled
The Inverter is in Standby mode. No loads
are detected at the output
Inverter mode is disabled
Battery voltage is too high
Inverter 1600 Pro is for the time being
turned off. Turning it back on will follow
automatically!
Absorption time is running
29