Wiring Example - Schüco 1600 Pro Manual Del Usuario

3.5.3 Connecting the 230V AC-Consumer
Appliance (AC OUTPUT)
The 230V consumer appliance must be connected to the
already installed AC-output cable.
3.5.4 Connecting the 230V AC Input
The 230V-supply from utility grid or from a generator
must be connected to the already installed AC-output
cable.
3.5.5 Connection to Remote control
The Remote Control Pro is connected in the terminal
marked „Remote control" with a RJ11/8 connector. The
Remote Control can be plugged IN or plugged OUT
during any operation situation.
Push in the connector, without forcing it, until you hear
the „click", now the connector is locked in place. The
same applies to the plug in the Remote Control. The
length of the cable for Remote Control should not
exceed 40m. We deliver it with 20m cable.
3.5.6 Connection to Temperature Sensor
The Temperature sensor TS Pro is connected in the
terminal marked „Temp" with a RJ11/6 connector.
The Temperature Sensor can be plugged IN or plugged
OUT during any operating situation.
Push in the connector without forcing it, until you hear a
„click", now the connector is locked in place.
The Temperature Sensor must be glued to the wall of
the battery or close to it. The Temperature Sensor cable
must not be tied together with the battery cables or laid
in a rope/bundle.
02.2008

3.5.7 Wiring example

Modul
Remote Control Pro (Optional)
Inverter 1600 Pro
AC output cable to be wired or connected to user
(socket not delivered)
AC input cable to be wired or connected to Utility
grid or generator (Plug not delivered)
TS-Pro, Temperature sensor (Optional) affi xed
nearby or on the battery
Battery
Fuse on battery cable (Not delivered)
Battery Charger
231 575 27