Battery Capacity; Charging Battery Pack; Battery Charging Procedure - Craftsman 151.98834 Manual Del Usuario

BATTERY PACK AND CHARGER
BATTERY LED PANEL
■ The panel consists of 2 LEDs on the face
of the battery. Press the panel button for the
LEDs to show you the charge level of the
battery.
■ The battery charge level can be checked
when the battery is attached or removed from
the mower.
Power Indicator LEDs
Button
BATTERY LEDS
COLOR

BATTERY CAPACITY

Green
Orange
Red 0-25% (Recharge required)
50%~100 %
25%~ 50%
16 ― English

CHARGING BATTERY PACK

See Figure 19, page iv
WARNING!
■ If any part of the charger is missing or
damaged, do not operate it! Replace the
charger with a new one. Failure to heed this
warning could result in possible serious injury.
■ Check the voltage! The voltage must
comply with the information on the rating
label.

BATTERY CHARGING PROCEDURE

■ Align the two slots on the underside of
the battery pack with the two edges of the
terminal plate on the side of the charger
body. Slide battery pack down until it locks
into place.
■ Connect the charger to the power supply.
■ Allow sufficient charging time (see Product
Specifications), and then disconnect the
charger from the power supply.
■ Press the release button on the battery
pack and remove it from the charger.
NOTE: It is normal for the battery pack and
charger to become warm (but not hot) during
charging process. If the battery does not
charge properly, check to make sure the
electrical outlet is operational. Always charge
the battery before storage!