Portfolio E3A Manual De Instrucciones página 4

PREPARATION
Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or damaged, do
not attempt to assemble, install or operate the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Concrete, Phillips Screwdriver, Pliers, 1/2 in. Wrench,
1/2 in. Ring Spanner.
Helpful Items: Flathead Screwdriver, Wire Cutters, Ladder, Wire Stripper, Electrical Tape.
ASSEMBLY INSTRUCTIONS
1. Excavate an area in the ground deep enough to enclose the
height of the anchor bolts (BB) and wide enough for the
mounting bracket (AA). Route the electrical wires from the
power supply underground and out through the middle of
the installation area. Screw the anchor bolts (BB) into the
mounting bracket (AA) to the end. Fill hole with concrete
(not included) and insert the assembly before the concrete
dries.
Note: The mounting bracket (AA) should be at ground level,
with the anchor bolts (BB) 1.9 in. above the ground. The
approximate length of supply wires that should be out of the
concrete 6-8 inches.
.
Hardware Used
Mounting Bracket
AA
Anchor Bolt
BB
2. Remove the preassembled screws from the base (D) with
a Phillips screwdriver (not included). Save for later use.
Attach adapter (A) to middle pole (B) by twisting it on
clockwise.
x 1
x 3
4