Hardware Contents; Safety Information - Portfolio E3A Manual De Instrucciones

HARDWARE CONTENTS

AA
Mounting Bracket
Qty. 1

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING:
●Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by
removing fuse (or switching off circuit breaker).
●Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not
permit wires to contact any surface having a sharp edge. To do so may damage or cut the wire
insulation, which could cause serious injury or death from electric shock.
CAUTION:
●All electrical connections must be in agreement with local codes, ordinances or the National
Electric Code (NEC). Contact your municipal building department to learn about your local codes,
permits and/or inspections.
●Risk of fire — most dwellings built before 1985 have supply wire rated for 140ºF. Consult a
qualified electrician before installation.
●Do not connect this fixture to an electrical system that does not provide a means for equipment
grounding. Never use a fixture in a two-wire system that is not grounded. If you are not sure your
lighting system has a grounding means, do not attempt to install this fixture. Contact a qualified,
licensed electrician for information with regards to proper grounding methods as required by the
local electrical code in your area.
●If a dimmer control switch is used with this fixture, obtain professional advice to determine the
correct type and electrical rating required.
(not shown actual size)
BB CC
Anchor Bolt Cap Nut
Qty. 3 Qty. 3
DD
Washer
Qty. 3
3
EE FF
Wire Nut Wrench
Qty. 3 Qty. 1