DeWalt DWE4212 Manual De Instrucciones página 40

ENglIsh

WARNING: A closed, two-sided cutting wheel guard
is re quired when using cutting wheels.

WARNING: Use of a damaged flange or guard or fail-
ure to use proper flange and guard can re sult in injury
due to wheel breakage and wheel contact. See the
accessories Chart for more information.
1. Place the tool on a table, guard up.
2. Install the unthreaded backing flange
with the raised center (pilot) facing the wheel.
3. Place wheel against the backing flange, centering the
wheel on the raised center (pilot) of the backing flange.
4. While depressing the spindle lock button and with the
hex depressions facing away from the wheel, thread the
clamp nut 5 on spindle so that the lugs engage the
two slots in the spindle.
5. While depressing the spindle lock button, tighten the
locking flange with a wrench
6. To remove the wheel, depress the spindle lock button
and loosen the threaded locking flange with a wrench.
Fig. E
17
Mounting Sanding Backing Pads
(Fig. A, F)
NoTE: Use of a guard with sanding discs that use backing
pads, often called fiber resin discs, is not required. Since a
guard is not required for these accessories, the guard may or
may not fit correctly if used.

WARNING: Failure to properly seat the flange/ clamp
nut/ wheel could result in serious injury (or damage to
the tool or wheel).

WARNING: Proper guard must be reinstalled for
grinding wheel, cutting wheel, sanding flap disc,
38
4 on spindle 2
17 .
5
4
2
wire brush or wire wheel applications after sanding
applications are complete.
1. Place or appropriately thread backing pad on
the spindle.
2. Place the sanding disc on the backing pad.
3. While depressing spindle lock
on spindle, piloting the raised hub on the clamp nut
into the center of san ding disc and backing pad.
4. Tighten the clamp nut by hand. Then depress the
spindle lock button while turning the sanding disc until
the sanding disc and clamp nut are snug.
5. To remove the wheel, grasp and turn the backing
pad and sanding pad while depressing the spindle
lock button.
Fig. F
18
Mounting and Removing Hubbed
Wheels (Fig. A)
Hubbed wheels install directly on the M14 threaded spindle.
Thread of accessory must match thread of spindle.
1. Remove backing flange by pulling away from tool.
2. Thread the wheel on the spindle
3. Depress the spindle lock button
tighten the hub of the wheel.
4. Reverse the above procedure to remove the wheel.
NOTICE: Failure to properly seat the wheel before
turning the tool on may result in damage to the tool
or the wheel.
Mounting Wire Cup Brushes and
Wire Wheels (Fig. A)

WARNING: Failure to properly seat the flange/ clamp
nut/ wheel could result in serious injury (or damage to
the tool or wheel).

CAUTION: To reduce the risk of personal injury,
wear work gloves when handling wire brushes
and wheels. They can become sharp.

CAUTION: To reduce the risk of damage to the
tool, wheel or brush must not touch guard when
mounted or while in use. Undetectable damage
could occur to the accessory, causing wires to
fragment from accessory wheel or cup.
, thread clamp nut
1 18
2 by hand.
1 and use a wrench to