Recommended Fire-Extinguishing Devices; Glossary; Trouble Shooting - Mondolfo Ferro AQUILA RAPTOR Manual De Uso

- Also adopt the following preventive and pro-
tective equipment:
• gloves resistant to mineral oils, with li-
ning;
• goggles, in case of splashes;
• aprons resistant to mineral oils;
• screens to protect against oil splashes.
m :
ineral oil first aid proCedures
- Swallowing: seek medical attention, providing
the characteristics of the type of oil swallo-
wed.
- Inhalation: in case of exposure to high concen-
trations of fumes or mists, take the affected
person to the open air and seek medical
attention immediately.
- Eyes: rinse with plenty of running water and
seek medical attention as soon as possible.
- Skin: wash with soap and water.
RECOMMENDED FIRE-
EXTINGUISHING DEVICES
For guidance on the most suitable type of ex-
tinguisher, refer to the table below:
Dry mate-
rials
YES
Water
YES
Foam
Powder YES*
CO YES*
2
YES* Use only if more appropriate extinguishers
are not at hand or when the fire is small.
WARNING
This table contains general instructions in-
tended to be used as guidelines for users.
Contact the manufacturer for details of the
applications of each type of extinguisher.
76
Flam- Electrical
mable equip-
liquids ment
NO NO
YES
NO
YES YES
YES YES

GLOSSARY

Air delivery regulator. Union allowing regu-
lation of the air flow.
Beading. Operation which takes place during
inflation and ensures perfect centring between
the bead and the rim edge.
Bead breaking. Operation in which the bead
of the tyre is detached from the edge of the
rim.
Bead pressing gripper. A tool intended for use
when mounting the top bead. It is fitted so that
it grips the shoulder of the rim and holds the tyre
top bead inside the drop centre. It is generally
used for mounting low profile tyres.
Tubeless Inflator. An inflation system which
simplifies inflating tubeless tyres.

TROUBLE SHOOTING

t
urntable will not turn
Power cord conductor shorting to ground.
• Check the wiring.
Motor shorted.
• Replace the motor.
• Replace motoinverter circuit board.
• Check pedal board micro.
Belt broken.
• Replace belt.
r
otation Control pedal fails to return
to Central position
Control spring broken.
• Replace the control spring.
b
ead breaking unit not working
No vertical movement.
• Check for folded hoses.
• Check ascent and descent valve operation.
b
ead breaking unit is underpowered
not break the bead and is leaking air
Carry out the checks in the previous point:
"Bead breaking unit not working".
Cylinder gaskets worn.
• Replace gaskets.
• Replace bead breaker cylinder.
- E
,
- Operator's manual
nglIsh
does