Tools - Faro GAGE Guia De Inicio Rapido De La Computadora Y El Software

5. MM/IN switch
• Use the MM/IN switch to set the measuring units for your part.
Note: Changing the measuring units will reset the Tools list. Always
select the correct units before selecting any Tools.
Measure your part with the Tools from the FARO Gage Toolbox. The Tools
are a combination of measurements and calculations.
• Angles - Measure angles between features on your part.
• Distance - Measure the distance between features on your part.
• Geometry - Measure geometric shapes, such as; Faces, Holes,
Edges, Points, Spheres, etc. on your part.
• GD&T - Measure your part using the GD&T system. Features and
Feature Datums will be measured in each command.
Measurement results display after a measurement is complete and out
of tolerance. Accept these results, or remeasure. The Tool results display
after the last measurement and the calculation are complete.
Gage mode
t
ooLS
P e-6
age