Aesculap Power Systems
Acculan® 3Ti attachments
3.
Drill and reamer attachments
Abb. 1
3.1 Intended use
Drill and reamer attachments are used to adapt
rotating tools applied in bone surgery for work on
bones and cartilage.
3.2 Operating principle
The drill and reamer attachments are powered by a
motor coupled through an Aesculap Acculan® 3Ti
coupling.
The drill and reamer attachments convert the motor
rotation to rotation of the tool adapted in the
respective attachment.
The drill and reamer attachments can be coupled to
the drive unit in three different angular positions at
steps of 120°.
Drill attachments are identified by their black
unlocking sleeves, whereas reamer attachments come
with blue unlocking sleeves.
4
3.3 Safe operation
Risk of injury due to heat necrosis!
Do not use drill attachments to
operate reamer tools such as the
DANGER
acetabulum reamer and the
medullary reamer.
Operate any reamer tool only
with a reamer attachment.
Recommended application
Use GB630R, GB634R, GB635R, GB636R, GB637R and
GB638R only for drilling and tapping.
Use GB654R, GB655R and GB656R only for acetabular
reaming and medullary reaming.
For information on how to connect the drill and
reamer attachments, siehe Coupling and uncou-
pling of attachments on the drill and reamer motor
unit.
Coupling a tool
Slide back unlocking sleeve 2.1.
Push the tool shaft in its proper position down to
the stop in the tool adapter of the attachment.
Release unlocking sleeve 2.1.
The tool is now coupled.
Uncoupling a tool
Slide back unlocking sleeve 2.1.
Remove the tool.