Electrical Installation; During Operation; Maintenance; Conventions In This Document - Dräger Polytron 6100 EC WL Instrucciones De Uso

– Protect the antenna connector from contamination and corrosion. If no
antenna is installed, attach cover cap (delivery state) and fasten hand-tight.
1.5

Electrical installation

– Use of the battery pack:
– Do not throw the battery pack into the fire.
– Do not open the battery pack forcibly.
– Dispose of the battery pack in accordance with national regulations.
– For wired power supply in hazardous areas, observe the specified
operational parameters and use a suitable safety barrier (see "Technical
data", page 52). Otherwise, intrinsic safety is not guaranteed.
– If the device is operated without a safety barrier, it is no longer approved for
use in hazardous areas.
1.6

During operation

– Check the calibration and functionality of the device after the presence of
dust deposits, immersion in liquids, or contact with water jets.
1.7

Maintenance

– Service the device at regular intervals. The intervals and activities are
defined in the maintenance schedule by the person responsible for the gas
detection system.
Dräger recommends carrying out the following activities every 6 months:
– Test the signal chain by applying target gas to the sensor.
– Check the LED display functionality with the Dräger PolySoft
configuration software.
– Service the sensor (e.g., change selective filter).
– Calibrate the sensor (see "Calibration", page 42).
– Observe valid national regulations regarding maintenance (e.g.,
EN 60079-29-2, EN 45544-4, T021/T023).
Instructions for use |
Dräger Polytron
®
6100 EC WL, Dräger Polytron

Conventions in this document

2 Conventions in this document
This document refers to the gas detector Polytron
®
repeater Dräger Polytron Repeater ISA.
The term "gas detector" is used for all contents. Contents relating to the
measuring function apply only to the gas detector Polytron
2.1

Meaning of the warning notes

The following warning notes are used in this document to notify users of
possible dangers. The meanings of the warning notes are defined as follows:
Alert icon Signal word
WARNING
CAUTION
NOTICE
2.2

Trademarks

Trademark Trademark owner
Aegex Technologies, LLC
TM
aegex10
EX80 Getac Technology GmbH
® Bluetooth SIG, Inc.
Bluetooth
ISA100 Wireless Compliance Institute
™
ISA100 Wireless
®
Repeater ISA
®
6100 EC WL and the
®
6100 EC WL.
Consequences in case of nonob-
servance
Indicates a potentially hazardous situa-
tion which, if not avoided, could result in
death or serious injury.
Indicates a potentially hazardous situa-
tion which, if not avoided, could result in
injury. It may also be used to alert
against unsafe practices.
Indicates a potentially hazardous situa-
tion which, if not avoided, could result in
damage to the product or environment.
| en
33